← Back to selected work

Analog electronics / Simulation / Measurement

Two-stage cascade BJT amplifier

Completed as describedBJT amplifierLTspiceBreadboardOscilloscope

A hand-designed two-stage amplifier was simulated in LTspice, built on a breadboard and physically measured.

200 mVpp20 Vpp100× / 40 dB

01 / Objective

The engineering task

Design a two-stage cascade amplifier, compare calculations with an LTspice simulation, then build and measure the prototype.

02 / Approach

From idea to implementation

From calculations to LTspice

The amplifier was designed by hand and simulated in LTspice before being assembled. The available brief does not include component values, supply rails, transistor model or frequency conditions.

Breadboard and measurement

The circuit was built on a breadboard and physically measured. Thabang reports that the measured results matched his calculations.

03 / Engineering details

What this work demonstrates

  • Verified scopeThe reported input was 200 mVpp (0.2 Vpp).
  • Verified scopeThe reported output was 20 Vpp.
  • Verified scopeThis produces a calculated voltage gain of 100x and 40 dB using 20 × log10(100).
200 mVppreported input
20 Vppreported output
100×voltage gain
40 dBcalculated gain

04 / Outcome

A completed learning example.

Completed as described by Thabang. These values are reported prototype results, not a comprehensive frequency-response characterisation or independent certification.

The images shown here were supplied for the local review candidate. The brief reports 200 mVpp input and 20 Vpp output; the oscilloscope capture itself displays a separate 220 mVpp input capture.

05 / Evidence

From simulation to the bench.